in maps/ichxrom.c [90:316]
static int __init ichxrom_init_one(struct pci_dev *pdev,
const struct pci_device_id *ent)
{
static char *rom_probe_types[] = { "cfi_probe", "jedec_probe", NULL };
struct ichxrom_window *window = &ichxrom_window;
struct ichxrom_map_info *map = NULL;
unsigned long map_top;
u8 byte;
u16 word;
/* For now I just handle the ichx and I assume there
* are not a lot of resources up at the top of the address
* space. It is possible to handle other devices in the
* top 16MB but it is very painful. Also since
* you can only really attach a FWH to an ICHX there
* a number of simplifications you can make.
*
* Also you can page firmware hubs if an 8MB window isn't enough
* but don't currently handle that case either.
*/
window->pdev = pdev;
/* Find a region continuous to the end of the ROM window */
window->phys = 0;
pci_read_config_byte(pdev, FWH_DEC_EN1, &byte);
if (byte == 0xff) {
window->phys = 0xffc00000;
pci_read_config_byte(pdev, FWH_DEC_EN2, &byte);
if ((byte & 0x0f) == 0x0f) {
window->phys = 0xff400000;
}
else if ((byte & 0x0e) == 0x0e) {
window->phys = 0xff500000;
}
else if ((byte & 0x0c) == 0x0c) {
window->phys = 0xff600000;
}
else if ((byte & 0x08) == 0x08) {
window->phys = 0xff700000;
}
}
else if ((byte & 0xfe) == 0xfe) {
window->phys = 0xffc80000;
}
else if ((byte & 0xfc) == 0xfc) {
window->phys = 0xffd00000;
}
else if ((byte & 0xf8) == 0xf8) {
window->phys = 0xffd80000;
}
else if ((byte & 0xf0) == 0xf0) {
window->phys = 0xffe00000;
}
else if ((byte & 0xe0) == 0xe0) {
window->phys = 0xffe80000;
}
else if ((byte & 0xc0) == 0xc0) {
window->phys = 0xfff00000;
}
else if ((byte & 0x80) == 0x80) {
window->phys = 0xfff80000;
}
if (window->phys == 0) {
printk(KERN_ERR MOD_NAME ": Rom window is closed\n");
goto out;
}
window->phys -= 0x400000UL;
window->size = (0xffffffffUL - window->phys) + 1UL;
/* Enable writes through the rom window */
pci_read_config_word(pdev, BIOS_CNTL, &word);
if (!(word & 1) && (word & (1<<1))) {
/* The BIOS will generate an error if I enable
* this device, so don't even try.
*/
printk(KERN_ERR MOD_NAME ": firmware access control, I can't enable writes\n");
goto out;
}
pci_write_config_word(pdev, BIOS_CNTL, word | 1);
/*
* Try to reserve the window mem region. If this fails then
* it is likely due to the window being "reserved" by the BIOS.
*/
window->rsrc.name = MOD_NAME;
window->rsrc.start = window->phys;
window->rsrc.end = window->phys + window->size - 1;
window->rsrc.flags = IORESOURCE_MEM | IORESOURCE_BUSY;
if (request_resource(&iomem_resource, &window->rsrc)) {
window->rsrc.parent = NULL;
printk(KERN_DEBUG MOD_NAME ": "
"%s(): Unable to register resource %pR - kernel bug?\n",
__func__, &window->rsrc);
}
/* Map the firmware hub into my address space. */
window->virt = ioremap(window->phys, window->size);
if (!window->virt) {
printk(KERN_ERR MOD_NAME ": ioremap(%08lx, %08lx) failed\n",
window->phys, window->size);
goto out;
}
/* Get the first address to look for an rom chip at */
map_top = window->phys;
if ((window->phys & 0x3fffff) != 0) {
map_top = window->phys + 0x400000;
}
#if 1
/* The probe sequence run over the firmware hub lock
* registers sets them to 0x7 (no access).
* Probe at most the last 4M of the address space.
*/
if (map_top < 0xffc00000) {
map_top = 0xffc00000;
}
#endif
/* Loop through and look for rom chips */
while((map_top - 1) < 0xffffffffUL) {
struct cfi_private *cfi;
unsigned long offset;
int i;
if (!map) {
map = kmalloc(sizeof(*map), GFP_KERNEL);
if (!map)
goto out;
}
memset(map, 0, sizeof(*map));
INIT_LIST_HEAD(&map->list);
map->map.name = map->map_name;
map->map.phys = map_top;
offset = map_top - window->phys;
map->map.virt = (void __iomem *)
(((unsigned long)(window->virt)) + offset);
map->map.size = 0xffffffffUL - map_top + 1UL;
/* Set the name of the map to the address I am trying */
sprintf(map->map_name, "%s @%08Lx",
MOD_NAME, (unsigned long long)map->map.phys);
/* Firmware hubs only use vpp when being programmed
* in a factory setting. So in-place programming
* needs to use a different method.
*/
for(map->map.bankwidth = 32; map->map.bankwidth;
map->map.bankwidth >>= 1)
{
char **probe_type;
/* Skip bankwidths that are not supported */
if (!map_bankwidth_supported(map->map.bankwidth))
continue;
/* Setup the map methods */
simple_map_init(&map->map);
/* Try all of the probe methods */
probe_type = rom_probe_types;
for(; *probe_type; probe_type++) {
map->mtd = do_map_probe(*probe_type, &map->map);
if (map->mtd)
goto found;
}
}
map_top += ROM_PROBE_STEP_SIZE;
continue;
found:
/* Trim the size if we are larger than the map */
if (map->mtd->size > map->map.size) {
printk(KERN_WARNING MOD_NAME
" rom(%llu) larger than window(%lu). fixing...\n",
(unsigned long long)map->mtd->size, map->map.size);
map->mtd->size = map->map.size;
}
if (window->rsrc.parent) {
/*
* Registering the MTD device in iomem may not be possible
* if there is a BIOS "reserved" and BUSY range. If this
* fails then continue anyway.
*/
map->rsrc.name = map->map_name;
map->rsrc.start = map->map.phys;
map->rsrc.end = map->map.phys + map->mtd->size - 1;
map->rsrc.flags = IORESOURCE_MEM | IORESOURCE_BUSY;
if (request_resource(&window->rsrc, &map->rsrc)) {
printk(KERN_ERR MOD_NAME
": cannot reserve MTD resource\n");
map->rsrc.parent = NULL;
}
}
/* Make the whole region visible in the map */
map->map.virt = window->virt;
map->map.phys = window->phys;
cfi = map->map.fldrv_priv;
for(i = 0; i < cfi->numchips; i++) {
cfi->chips[i].start += offset;
}
/* Now that the mtd devices is complete claim and export it */
map->mtd->owner = THIS_MODULE;
if (mtd_device_register(map->mtd, NULL, 0)) {
map_destroy(map->mtd);
map->mtd = NULL;
goto out;
}
/* Calculate the new value of map_top */
map_top += map->mtd->size;
/* File away the map structure */
list_add(&map->list, &window->maps);
map = NULL;
}
out:
/* Free any left over map structures */
kfree(map);
/* See if I have any map structures */
if (list_empty(&window->maps)) {
ichxrom_cleanup(window);
return -ENODEV;
}
return 0;
}